Setup guide

Page 28 Dedicated Micros
Function Description
Serial1 & Serial2 Serial ports 1 & 2 are RS-232 ports and can have the following port
usage assigned; off, debug, general purpose, PPP and text in image,
RS232 telemetry.
Serial 3 & 4
(Bus A and Bus B)
Serial ports 3 & 4 are RS-232, RS-422 and RS-485 ports and can have
the following port usage assigned; off, debug, general purpose, text in
image, RS232/485 telemetry.
Telemetry type This is the list of serial telemetry protocols that are supported on the
Digital Sprite 2.
Telemetry Matrix
Monitor
Matrices support many monitor outputs, this is the monitor output that
has been allocated for connection to the Digital Sprite 2.
Telemetry Matrix
Offset
This is the matrix offset to allow any camera input on the matrix to be set
as input 1 for the Digital Sprite 2. An example of this is in large systems
where multiple operators are allocated groups of cameras, for ease of
use each camera can be configured to start at camera 1. However they
could actually be connected to any input on the matrix but we would
select camera 1 which could be controlling input 32 on the matrix.
Baud rate, parity,
data bits, stop bits,
flow control
This allows the communication settings to be configured, note when
telemetry is selected these will not be active and will default to
predetermined settings.