Setup guide

Page 26 Dedicated Micros
Telemetry Setup Page
1. To access the set up parameters of the camera select the Telemetry Setup button on the
Camera Set-up page.
2. The telemetry control buttons for configuration will be displayed along with camera selection,
display options and resolution selection.
This web page allows the Operator to view any of the enabled inputs on the Digital Sprite 2,
control the telemetry connected to the system and set up any features that are required for their
application (such as presets). It is also possible to access the dome/PTZ camera menus for
configuration of the supported parameters that are only programmable from the camera menu.
How to Configure Matrix Control
The Digital Sprite 2 can be incorporated into an existing analogue matrix
installation and offers control of the matrix via the Live web page or the Viewer
software.
This ensures that any existing equipment does not need to be removed from
the installation to allow control over a network, simply integrate the Digital Sprite
2 into the system a network output.
Function Description
Baud rate, parity,
data bits, stop bits,
flow control
This allows the communication settings to be configured, note when
telemetry is selected these will not be active and will default to
predetermined settings.
Note: When you select the Telemetry Setup button, it may take a few seconds for the
page and video to be downloaded, during this time do not continually press any
buttons as this will slow the process down.
Note: Review the relevant documentation for the camera to see how you navigate the
camera menus. Remember to save any configuration settings in the dome menu!