Setup guide

Page 24 Dedicated Micros
This web page allows the Operator to view any of the enabled inputs on the Digital Sprite 2,
control the telemetry connected to the system and set up any features that are required for their
application (such as presets). It is also possible to access the dome/PTZ camera menus for
configuration of the supported parameters that are only programmable from the camera menu.
How to Enable Serial Telemetry
The Digital Sprite 2 supports numerous serial telemetry protocols, any of the
video inputs on the Digital Sprite 2 can be configured as a functional camera.
Serial 3 (Bus A) and Serial 4 (Bus B) can be used for connecting serial
telemetry.
Common telemetry operations such as pan, tilt, zoom, presets can be
controlled via the Live page of the web interface or via the Viewer software.
The current 485 serial protocols supported on the Digital sprite 2 are:
1. Connect the camera and cables to the Digital Sprite 2 before configuring the unit:
2. Select System -> Serial Ports & Telemetry.
3. Using the drop down list on the associated Communication port (Serial 3 (Bus A) or Serial 4
(Bus B)) select RS232/485 Telemetry.
4. Select the relevant telemetry type from the list of supported protocols.
Note: Review the relevant documentation for the camera to see how you navigate the
camera menus. Remember to save any configuration settings in the dome menu!
BBV-RS485 JVC Pelco-P Ultrack
DM-Serial Kalatel Philips Vantage
Dennard Mark Mercer Samsung VCL
Ernitec Panasonic Sensormatic Vista