Setup guide

Dedicated Micros Page 19
Configuring the Network Settings of the Digital Sprite 2
The Digital Sprite 2 can be allocated an IP address and associated settings via
the serial port or OSD menus, this web page allows these settings to be
checked and changed if required.
To check / configure the network information:
1. Select Network -> Network Settings.
2. If the IP address, subnet mask and default gateway that has already been configured via
the serial port or OSD menus these will be displayed on this page, these can be changed by
entering the new information in the relevant areas.
3. The Digital Sprite 2 supports Domain Name Server allowing the Digital Sprite 2 to reference
other hosts by their name rather than their IP address, enter the IP address of the primary DNS
and secondary DNS server.
4. The default system name for the Digital Sprite 2 is DS2, this can be changed to a more
appropriate name by entering the information in this section.
5. As the Digital Sprite 2 can be connected to a LAN or WAN network it is possible to identify the
maximum bit rate for the network connection. There are default settings for LAN, WAN and
ISDN if these defaults are accept select the corresponding button for your network link, the Max
trans rate, transmit image buffers and Ethernet MTU values will be automatically configured, if
these default settings are not as require enter the new information in the sections.
6. Enter the TCP Re-transmit Time in milliseconds, this settings should be discussed with the
Network Manager.
6. The secondary webserver port is system specific and allows a port to be allocated for
webserving if the network is already utilising the default port.
8. Remember to save the configuration by selecting Save Settings!