Setup guide

Advanced Setup
The Digital Sprite 2 supports MJPEG and MPEG4 compression. the Advanced Setup option
allows the JPEG settings to be aliased for MPEG4 mode so that the User Interface allows
dynamic switching between viewing MJPEG or MPEG4 images.
To configure the Advanced Setup:
1. Select Cameras -> Camera Setup -> Advanced Setup.
2. Enter the JPEG file sizes in Kbytes for the various image resolutions; 2CIFHI, 2CIFMED,
2CIFLO, CIF, QCIF.
3. Enter the bit rate for the equivalent MPEG4 images for the same image resolution.
4. Enter the number of pictures per second required for MPEG4 compression.
5. Remember to save the configuration, select Save Settings!
Dedicated Micros Page 17
Function Description
System Resolution This is a read only section and identifies the resolution as configured in
the Camera Setup page.
Resolution Codes There are a number of resolution codes that identify the size of the
image that will be transmitted when the corresponding resolution button
is selected in the User Interface.
Note: These figures are automatically calculated by the unit are are
dependent on the Resolution setting selected in the Camera Setup
JPEG (Kbytes) This is the maximum JPEG file size for each of the resolution options,
enter the values in Kbytes.
MPEG4 Bitrates
and Frame rates
This is the maximum bit rate and required framerate when the unit is in
MPEG4 mode for each of the resolution options, enter the value in
kbits/second and pictures per second (respectively).