Setup guide

Dedicated Micros Page 145

System Logs

There are a number of system logs supported on the Digital Sprite 2, these logs can be viewed

and used for Administration purpose.

Each log requires enabling to ensure entries are created by the Digital Sprite 2.

Function Description

Open TCP Port, Entry

XX From Port, Entry

XX To Port

This identifies the TCP ports that are supported on the system and

available. If a host tries to communicate with the Digital Sprite 2

using a TCP port that is not in the list, even with a valid IP address,

the host will not gain access to the unit.

Enter the port range that are to be supported in the From and To

settings.

Open UDP Port, Entry

XX From Port, Entry

XX To Port

This identifies the UDP ports that are supported on the system and

available. If a host tries to communicate with the Digital Sprite 2

using a UDP port that is not in the list, even with a valid IP address,

the host will not gain access to the unit.

Enter the port range that are to be supported in the From and To

settings.

Note: The TCP ports entered in this section must also be enabled on the network,

check with the Network Administrator.

Note: The UDP ports entered in this section must also be enabled on the network,

check with the Network Administrator.

System Logs

PPP connections Disabled

Disabled, Enabled View

Illegal file access Disabled

Disabled, Enabled View