Setup guide

Page 138 Dedicated Micros
Function Description
Destination Number Enter the GSM number for the SMS server. The number should be
entered in international format including the country code and local
area code.
Destination URL If the SMS message is to be sent over TCP/IP, enter the URL or the
IP address of the SMS Server.
SMS Server It is possible to enable the Digital Sprite 2 to become an SMS Server
to receive and log SMS message, highlight the option and press to
switch between enabled / disabled.
Report Settings An SMS message can be automatically transmitted when the unit
identifies specific events.
Callback Profile 0
This identifies the route the return message, from the Operator
mobile device, will take.
The return message must contain the SMS command password,
callback IP address (IP address of the remote PC with the Viewing
application) and the command to action the Digital Sprite 2 to
automatically call the remote station.
Callback Profile 1
This allows an alternative profile to be configured to work as a back-
up or alternative route for the return message from the Operators
mobile device.
The options are to configure the setting use the and keys to
scroll through the available options or the default settings is
Ethernet.
SMS Command
Password
This is the password to enable the SMS commands to be initiated
and transmitted from the Digital Sprite 2 to the mobile device.
This password will be included in the return text from the Operator.
Use the and keys to scroll through the available characters.
When the password had been configured highlight OK and press the
MENU key to return to the SMS Setting menu.
Advanced Settings These settings are specific to the GSM module connected to the
Digital Sprite 2.
Note: The SMS messages will be sent over an Ethernet link if present, alternatively it
will be sent over the GSM network.
Note: The Verbose option must not be enabled on the client DVR’s when this option
is selected.