Setup guide

Page 128 Dedicated Micros
The Digital Sprite 2 supports GSM communications and SMS messaging. This allows the Digital
Sprite 2 to report events via SMS and to receive SMS messages in order to create events on the
system.
Command Format
The commands consist of a descriptor followed by a variable parameter list. The order in which
the parameters appear must follow the format detailed below.
SMS Commands
These are messages that are sent to the Digital Sprite 2 to force an event to be triggered on the
unit. These messages can be sent from a mobile phone or an Internet Service Provider (ISP)
supporting SMS messaging.
Callback
This command is used to force the Digital Sprite 2 to make a connection to an Alarm Receiving
Centre where the telnet listener (telserve) application is running.
CALLBACK?<password>&<destination>&<profile>&<text>
Appendix F – SMS Message Format
password This is the SMS password that has been identified in the SMS Set-up
page and enables the command to be executed.
destination This is the IP address or DNS name of the Viewing application that
has telserver (Telnet listener) enabled to receive the message.
profile This can be a number or name that has been configured on the SMS
Set-up page, this will be via the serial port or Ethernet connection.
text This is the text message that will be sent to the remote viewer
informing the Operator of an incident and therefore should be
meaningful.