Operating Instructions and Installation Instructions

CamVu 2000

DRAFT

Firewall

This page allows conguration of the onboard rewall.

Enable PING response

By default this option is enabled and allows the unit to be pinged.

Disabling this option will make the unit less visible on the network

Table Entry Up to 32 Conguration settings may be entered.

Open TCP ports This list identies the TCP ports that are on the system and available.

If a host tries to communicate with the unit using a TCP port that is

not in the list it will not gain access to the unit. The enabled ports can

be a range or single port address, if a single port is needed, enter the

same port number in the to and from section.

Open UDP ports This is the list of UDP ports that are available on the unit. If a host

tries to communicate with the unit using a UDP port that is not

specied in the list it will not gain access. The enabled ports can be a

range or single port address, if a single port is needed then enter the

same port number in the to and from section.

Refresh (Purple) Refreshes the current page