Operating Instructions and Installation Instructions

CamVu 2000

DRAFT

Video server port This eld allows the RVRC to connect to the unit through a router that

is using port forwarding e.g. if the video server does not appear on

port 80 (HTTP), to the external network. Enter the port number used

for forwarding here if required.

Alarm server ref. ID This is the reference name/ID that will be presented to the RVRC

viewing application. It should therefore have some signicance to the

Operator.

Remote alarm reporting This must be enabled for the unit to automatically connect

on alarm.

Remote camfail reporting Enabling this option ensures the unit reports camera failure on any of

the inputs to the RVRC.

Remote Startup Reporting This will send an alarm report when the unit starts up. Any system

resets will be identied.

ARC Ping Enabled

Should the modem/router at the Alarm Receiving Centre be dormant, the

unit will ‘Ping’ the ARC prior to sending reporting data.

Alarm responder port This species the network port number used for reporting to the alarm

server. In normal circumstances this should be left at the default value

(23).

Dial retry time (secs) If the initial connection attempt fails, the unit will wait for the specied

time period (in seconds) before attempting to re-connect.

Dial count This identies the number of times the unit will attempt to connect

after a failed attempt. A setting of ‘0’ means no limit and the unit will

continue to try and connect until successful.

Zone Act (Green) Opens the Alarm Settings -> Zone Actions page.

Network (Yellow) Opens the Network Settings -> Network page.

Email (Blue) Opens the Network Settings -> Email page.

Refresh (Purple) Refreshes the current page