Operating Instructions and Installation Instructions
Dedicated Micros ©2010
61
CamVu 2000
DRAFT
VMD/Act Response Setup
The unit can be set up to detect either VMD or Activity, depending on the level of detection required.
Video Motion Detection enables a greater degree of control over detection settings and conguration
than the Activity Setup function.
VMD Pulse Ext (s) A pulse extension is used to prevent double triggers on a single
alarm. The pulse extension time starts on an alarm trigger. If that
contact is triggered again after the rst alarm has nished but within
the pulse extension, the second trigger will not generate a new alarm,
but will extend the current alarm duration. Enter the time in seconds
for this extension.
Note: This setting applies to both VMD and Activity.
Channel Shows the channel being congured.
Detection Type To congure the selected camera channel for Activity, select ‘Activity’.
To assign no detection settings, select ‘None’.
Activity To Trigger Following Activity activation, select ‘Simple Response’ to trigger
specic chosen responses. Refer to ‘Activity Response Setup’ for
more information. Select ‘Zone’ to apply the Zone Input rules as
congured in the Zone Input menu. Refer to ‘Zone Input’ for
more information.
Create Database Entry When selected, an alarm entry will be added to the
Event database.