Operating Instructions and Installation Instructions

CamVu 2000

DRAFT

Step 5 - Connecting Audio

The CamVu 2000 support a single channel of bi-directional audio, accessible through NetVu ObserVer.

Connect the audio equipment to the 3.5mm stereo socket. The tip of the jack shall be used for audio input.

The following modes of operation are supported:

• Challenge – one way audio, DVR to camera, optionally recorded.

• Listen – one way audio from the camera to the DVR, optionally recorded.

• Help Point – two way audio, optionally recorded.

5.151

Step 6 - Connecting Power

Note: If the device utilises POE, this step would not be necessary. Connect the Network connector at

this stage, refer to ‘Power over Ethernet’ for details on available POE Injector.

The CamVu 2000 is supplied by a two way 3.81mm pitch screw terminal push t connector, separate to the

alarm connector.