Operating Instructions and Installation Instructions

CamVu Mini Dome

11 Visually align the screws on the dome front cover with the screw holes on the camera body to

assist in replacing the dome cover.

12 Replace the dome front cover and tighten the torx screws, taking care not to trap the retaining

cord in the edge of the front cover. Do not over-tighten the torx screws.

The power supply must be a class 2 isolated type.

Warning: This camera is a Class 2 device and therefore does not have an earth connection in

the power cord.

Note: To avoid unwanted reections all LEDs within the camera including those on the network

connector are disabled. The LEDs are enabled if SW1.1 (which is situated close to the alarms

connector of the main board) is turned ON.

Power over Ethernet

The camera can be powered from any suitable PoE injector conforming to IEEE 802.3-2008. End span and

bridging injectors supported.

POE Injector

The Dedicated Micros POE Injector is designed to enable the use of POE (Power over Ethernet) before a

POE capable switch has been installed. It is installed alongside a suitable 48Vdc PSU that can supply 15W

is required - DM/PSU/48V can be purchased separately from Dedicated Micros.