Operating Instructions and Installation Instructions

CamVu Mini Dome

8 Connect the Network to the RJ45 connector on the camera.

If not using PoE, connect the power cable to the power terminals.

The camera operates from a 12V DC power supply. Connections and polarity are indicated next

to the terminals. The power supply must be a UL Listed, Class 2 isolated type.

Note: A CAT5 cable must be used.

9 Fit the camera assembly back into its body and tighten the two captive screws.

10 Optionally attach a local monitor to the test point using an DM/ICED-SERV service connector

(available separately) and adjust the camera as described in the Camera Settings section.