Operating Instructions and Installation Instructions

CamVu Mini Dome

Installation

The ICE xed dome camera is available in two versions: both are surface mounted versions for installation

directly onto a hard surface or mounting structure.

Parts Supplied

CamVu Mini Dome Surface mount

4 x 5mm Wood screws

4 x Wall plugs

4 x 9.5mm O-rings

1 x T20 Security Torx key

This booklet

Parts Not Supplied

• Optional video service lead (part number DM/ICED-SERV)

• A PSU is not supplied with this camera. If the camera is used with Power over Ethernet (PoE)

it is not necessary to use a separate PSU (if PoE is available use the ethernet connection)

otherwise a suitable 12Vdc 0.5A PSU is required.

Alternatively a 12Vdc PSU(VS-PSU15W-EXT) can be purchased from Dedicated Micros.

INSTALLING YOUR CAMERA

Network and power cables enter the camera body inside a plastic or metal conduit either from the side or

rear of the camera, refer to Appendix B for a scale pattern.

1 Loosen the four torx screws on the front of the camera using the torx screw key supplied.

2 Gently pull away the dome cover from the camera body and remove the plastic shroud. The

dome cover is attached to the camera body with a retaining cord. Do not undo or cut this cord.

3 Unscrew the 2 captive screws at either side of the camera mount assembly and remove the

camera assembly from the body.