Operating Instructions and Installation Instructions

CamVu Mini Dome

Line Lock

Set to INT (internal) only. Phase is not adjustable on this product.

Day/Night

This switch sets the light level at which the camera automatically switches between day and night operation.

Hi sets the camera to switch between day and night mode at higher light level. Lo sets the switching point at

a lower light level. The default setting is Lo.

When in Night mode, the IR cut lter is removed allowing infra red illumination to be used.

Colour Burst

The Colour Burst (CB) switch allows the colour burst component of the signal to be turned on or off.

When a day/night camera switches to night (mono) mode, the colour burst can be switched OFF for a true

monochrome signal. Note that some multiplexers/recorders detect video-loss if the colour burst signal

disappears. If problems are encountered with the multiplexer/recorder when the camera switches to mono,

try setting CB to ON. Default is CB OFF.

Lens Level

Adjust the lens iris level according to the lighting conditions.

1 Turn the Automatic Gain Control switch OFF

2 Adjust the Lens Level potentiometer so that a 1 V peak-to-peak signal is

achieved. Use care so as not to damage the potentiometer.

3 Turn the Automatic Gain Control switch ON

Final Assy

When all the connections and adjustments have been made, re-attach the camera liner and dome cover.