Operating Instructions and Installation Instructions

CamVu Mini Dome

CAMERA SETTINGS (HYPERD VERSIONS ONLY)

To assist with the set up process, live video can be seen using the dome’s viewer web pages. Alternatively

an analogue service monitor can be attached to the dome test point using an DM/ICED-SERV service

connector (available separately).

Note: The analogue output is only active for 10 minutes after power up.

Entering the Menu

The two buttons marked A and B that are situated below the camera lens are used to set the camera. Press

these buttons to access and navigate the on screen menu as follows:

• To access the menu system, press A momentarily.

• To cycle through the menu items, press A repeatedly.

• To change the setting in the selected menu item or go to a supplementary menu page, press B.

• To save your settings, select Save and Exit and press B. Note that settings will be saved when

the menu times out.

Adjusting the Picture Settings

In most situations, the default settings give good quality results. However, in specic circumstances, the

following adjustments may improve performance.