Operating Instructions and Installation Instructions
Dedicated Micros ©2010
113
CamVu Mini Dome
‘NetVu ANPR’ - i.e. the HyperSense ANPR camera from
Dedicated Micros.
IP Mode Select the IP mode used to receive incoming IP data. Select from:
Simple Stream - Received IP streams are non-compressed and are
viewed as congured on the originating source.
Recode Stream - When selected, the unit will recompress the
incoming IP stream to the record prole settings
established for this camera channel in the Prole
Record menu (Record Settings->Prole Record).
This feature is only accessable with 3rd party IP
camera when the 3rd party IP camera license has
been enabled.
Remote codec When selected, the unit will utilise the codec in
the remote NetVu connected video server/camera
to allow change Multimode proles and perform
additional activities such as VMD and Activity
Detection as if the codec was an integral part of the
DVR. If ‘Remote codec’ is selected, the loading on
the unit’s internal codecs will be reduced.
IMPORTANT: The Remote codec option is only applicable for NetVu Connected cameras.
Note: Additional IP cameras ( further to existing local camera channels) are remote codec only.
Therefore any NetVu connected cameras will be applied above local camera level.
When ‘Simple Stream’ and ‘Recode Stream’ are selected via ‘IP Mode’, the following options will
be available:
IP Address Enter the URL address of the image source.
Channel If the URL is a multichannel device (e.g. DV-IP NV1), this species
which channel to use.
Live Trans (Red) Select to open the Network->Live Trans page
View Prole (Green) Select to open the Record Settings->Prole Record page
Basic (Yellow) Select to open the Serial Ports->Camera page.
Lens Setup (Blue) Select to open the Camera Lens Conguration page
Refresh (Purple) Refreshes the information on the current page.