User guide

CamVu D500 Minidome

Installation

The dome camera can be mounted in two ways: ceiling mount for installation into a tile ceiling; surface

mount for installation directly to a hard surface or mounting structure.

Parts Supplied

• 2 x Plastic anchors

• 2 x 80 mm (3”) screws

Parts Not Supplied

• Optional video service lead (part number DM/ICED-SERV)

Surface Mount Ceiling Mount

Surface Mount Installation

Refer to the Quickstart section for more information.

1 To remove the dome cover, rotate it counter-clockwise and gently pull it away from the camera

body. The inner liner can now be removed.

2 Using the template supplied at the rear of this manual, mark and drill the holes required for

xing. Using the two 80 mm mounting screws, attach the dome camera to the surface as

shown. Do not over tighten the xing screws. The screws can be used on their own if the

surface is of a suitable material (e.g. wood), but plastic anchors must be used where the

surface is of brick or masonry construction. Run the ethernet cable to the camera. Cable may

be fed through the ceiling or through the cutout in the side of the camera shroud. Remove the

cutout with a sharp knife and use a round le to smooth the edges if necessary.

3 Connect the ethernet cable to the RJ45 socket on the mainboard. If the camera is connected

to a switch that is not POE capable, refer to ‘POE Injector Cable‘ and install the POE injector

cable as described.