User guide

CamVu D500 Minidome

FCC CLASS B REGULATORY NOTICE

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)

This device may not cause harmful interference, and (2) this device must accept any interference received,

including interference that may cause undesired This equipment has been tested and found to comply

with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed

to provide reasonable protection against harmful interference in a residential installation. This equipment

generates uses and can radiate radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications. However, there is no guarantee

that interference will not occur in a particular installation. If this equipment does cause harmful interference

to radio or television reception, which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a different circuit different to the receiver.

Consult the dealer or an experienced radio/TV technician for help.

Modications not expressly approved by the manufacturer could void the user’s authority to

operate the equipment under FCC rules.

Read Instructions

All the safety and operating instructions should be read before the unit is operated and adhered to during

operation. These instructions should be retained with the unit, and all warnings and cautions contained

should be heeded.

Power Sources

This unit should be operated only from the type of power source indicated on the manufacturer’s label.

Power Over Ethernet

This product supports POE and when connected to a suitable switch, will not require an external PSU to

drive the device (Bridge and end-span compatible).

Servicing and Repair

Do not attempt to service this unit yourself as opening or removing covers may expose you to dangerous

voltage or other hazards.

Refer all servicing and repair to qualied service personnel.

Equipment

Use only attachments/accessories specied by the manufacturer.

Ventilation

Ensure unit is properly ventilated to protect from overheating.