Operating instructions

draft

DV-IP HD

Optical Zoom Limit Select to limit the Oracle Domes optical zoom function. By default

‘100x’ is selected and the camera can zoom to its maximum

capabilities. The optical zoom function can be limited to between

75% and 100% magnication.

Coax Gain If the Oracle Dome camera is connected to the unit via coaxial

cabling. The coax signal can be improved by increasing the

coaxial gain settings. Select a percentage gure between 1 and

100 until the optimum image quality is reached.

Coax Lift If the Oracle Dome camera is connected to the unit via coaxial

cabling. The coax signal can be improved by increasing the

coaxial lift settings. Coaxial lift differs from coaxial gain as only the

high end of the signal spectrum is effected. Select a percentage

gure between 1 and 100 until the optimum image quality is

reached.

White Balance The Oracle Domes White Balance feature enables the camera to

compensate for different lighting scenarios which can effect the

colour quality of the displayed image. Select ‘Auto’ for the camera

to auto-compensate for white balance depending on current view.

Select ‘Indoor’ to permanently set for best results in an indoor

setting. Select ‘Outdoor’ to permanently set for best results in an

outdoor setting.

Exposure The Oracle Domes Exposure setting can be set to maintain

optimum contrast settings for the viewed image/camera location.

Select ‘Full Auto’ for the camera to auto-compensate for best

exposure settings depending on current view. Select ‘Manual’ to

manually congure exposure settings. Select ‘Shutter Priority’ to

manually enter the shutter speed.

Shutter Speed If the Exposure feature is to be manually congured, enter the

shutter speed settings.

ICR The Oracle Dome camera is tted with an Infrared Cut function,

This feature helps remove excessive infrared light which can

signicantly reduce image quality. Select ‘On’ for this function to

permanently be active, ‘Off’ to deactivate, or ‘Auto’ for the unit to

only use the function when required.

ICR switching can also be triggered in response to an alarm

input. Ths allows a photocell sensor to be used to control when a

camera should switch from normal to low light mode (for optimal

performance). Alarms 1-4 can be selected as the controlling alarm

input for this action, refer to ‘Alarm Settings-Alarm Input’ for more

information.

UTP Boost If the Oracle Dome camera is connected to the unit via twisted

pair cabling. The UTP Boost function can be activated to improve

signal strength.