Operating instructions

draft

DV-IP HD

Installing the Unit

Before you start

Check the contents of the box

Remove all items from the packaging and check the items listed below are present.

• DV-IP HD DVR

• IR Remote Control

• IR Remote Control Extender

• Mouse

• Power Leads

•

DV-IP HD Software disc

If any of these items are missing, please contact Dedicated Micros Technical Support team.

Note: Before installing the DV-IP HD carefully read all Safety Instructions and the following

information on where the unit should be located.

Available Accessories

The following accessories can also used in conjunction with the DV-IP HD.

• KBC1 Keyboard

• KBC2 Keyboard

• Managed Storage Unit - Extend storage capacity to 5TB

• Managed Continous Archiving - Mirrored RAID1 storage unit

For further information about any of the above products, please contact Dedicated Micros customer

services in your region.

Choosing a location for installation

• The DV-IP HD is designed to be desk, shelf or rack mounted. Rack mounting brackets

are available as an optional accessory.

• Ensure the DV-IP HD unit is properly ventilated to protect from overheating.

•

Ensure there is a 3cm gap on both sides of the unit.

•

Ensure the IR receiver on the front of the unit faces the operator position, and is not

more than 3 metres (10 feet) from the operator. An IR Remote Control Extender is also

available.

• Ensure the unit is not located anywhere it could be subject to mechanical shocks.

•

The unit should be located in an area with low humidity and a minimum of dust. Avoid

places like damp basements or loft spaces.

• If the unit is to be installed in a closed assembly, the maximum operating temperature

must not exceed 40°C (104°F).

• Ensure there is reliable earthing of the mains outlet when tted to supply connections

(other than direct connection to the branch circuit).

• Any branch circuit supplying the unit must be rated at 15Amps.

•

It is recommended that an uninterrupted power source be connected to the unit in case

of power failure (to ensure continuous operation of the unit).