Operating instructions
draft
Dedicated Micros ©2008
76
DV-IP HD
E Mail
The unit can automatically transmit an e-mail to an SMTP Server under numerous conditions i.e. on
start up, on receipt of an alarm, or camera failure. This allows the unit to be installed in unmanned
applications where a Remote Video Response Centre (or Manager etc.) would be notied by e-mail
if any of these conditions occur.
Connection Prole It is possible for the e-mail to be transmitted via the Ethernet
network or dial up connection (PPP ‘Point to Point Protocol’).
This setting presumes that a modem has been connected or
congured and the unit is connected to a LAN or WAN and
allocated a valid IP address.
Mail Server Address This is the IP address or URL of the SMTP Server that the e-mail
will be sent to. The SMTP server will then forward this to the
intended recipient.
Recipient Email This is the e-mail address of the intended recipient.
Display Name (Recipient)
This is the addressee name that will be shown in the email name
eld.
Reply to Email This eld must be congured if the recipient is to reply to an e-
mail. The unit does not accept incoming e-mails therefore ensure
this is a valid e-mail address.
Display Name (Reply To) This is the ‘reply to’ name that will be shown in the email name
eld.
Sender Email These optional elds indicate the source of the e-mail notication.
If the elds are left blank the unit will use the system name & DNS
name to create a sender name.
Display Name (Sender) This is the sender name that will be shown in the email name
eld.
Send on Startup Select to send email notication on startup.