Operating instructions

draft

DV-IP HD

Increment (Green) Select to increase the size of selected hotspot by the ‘Increment

by’ setting.

Hotspot X co-ord Use to position the centre of the hotspot along the X axis e.g.

entering 20 would place the hotspot centre 20 pixels from the left

edge of the map.

Hotspot Y co-ord Use to position the centre of the hotspot along the Y axis e.g.

entering 20 would place the hotspot centre 20 pixels up from the

bottom edge of the map.

Note:

The hotspot can also be positioned by clicking directly on the map.

Hotspot Origin (deg) This option should be used when the hotspot relates to a PTZ

camera. Clicking the hotspot will send the PTZ camera to a

matching relative position, unless the centre of the hotspot

is selected in which case the camera will be viewed from the

current location.

This relative position will depend on the data entered in the

Hotspot Origin. A setting of ‘0’ would result in the camera facing

its Original (base) position. To change the preset position, enter a

number between 1 and 360. A setting of 20 would set the preset

position to 20 degrees to the right of its ‘origin’ position, 180

would send it opposite to the origin position. Refer to the ‘Viewer

Menus-PTZ Prole menu‘ for information on establishing an Origin

position for a PTZ camera.