Operating instructions

draft

104

DV-IP HD

PTZ Program Option

The Program page allows preset settings for PTZ cameras to be established and an ‘Origin’ base

position established for a camera.

Note: This page will not be available for all cameras.

Red Store Used to save the current camera view as a

Preset for that camera. Press this button then a

preset position (using the number keys on the IR

Remote Control or optional Keyboard if viewing

via a local monitor).

To re-send the camera to this position, select

the camera, then press Next -> Preset -> (preset

number).

Note: When entering a new preset, any previous preset assigned to that number (for the same

camera) will be overwritten.

Green Dome Menu Select to display menu pages displaying

information relevant to the connected camera.

Select the Dome Menu (Green) again to cycle

through available menus.

Yellow Select This option will send the camera to

the stored ‘Preset1’ position.

Blue Set Origin The Origin option allows a base position to

be established for the Oracle dome camera.

The camera will register this position as zero

degrees. Any command that sends the camera

to a coordinate will use this origin as its starting

point. Refer to ‘Console Settings-Map Cong

-Hotspot Origin’ for more information).

Note: This option is only available for Oracle dome cameras.

Purple Next Opens the next page of the Viewer menu.

Note: These menu options will only be available when viewing a PTZ camera in Live mode.