Load Table

Size in millimeters
Material used:
Alloy
Steel Q195
Main chords
25 x 25 x 1
mm
Braces
8 mm
Accessory/truss
4x bolts M8-8.8, 8x washer, 4x spring lock washer, 4x self locking nuts
Item No.
Maximum system length:
meters
Stand:
The load capacities given in this load table are based on calculations in accordance with EN 1993 and include the net
weight of the product of 5.4 kg/m. This load table is valid only for linear segments of the cross beam system DECOTRUSS
Quad ST 4-Way Cross Beam.
This product has been designed for static loads only. No dynamic loads. If dynamic loads are to be attached to the
system, the user has to provide appropiate proof.
Loads are to be attached only to the intersections of the braces and main chords. That applies to loads distributed over
the carrier length too.
07.07.2020
2,5 74 92 69 46 38
3 50 76 57 38 31
60112475
at the one-third
span points
at the one-
quarter span
points
at the one-fifth
span points
2 116 116 87 58 49
Quad ST- 2000 60112435 10,3
Quad ST- 1000 60112425 5,4
System components (straights):
Designation No. Weight
Quad ST- 500 60112415 3,0
(kg)
Quad ST
56205 157 101 721,5
(m) (kg/m) (kg) (kg) (kg) (kg)
Load table Quad ST:
Span UDL Point load
4-Way Cross Beam
3,5 36 64 48 32 27
4 27 54 41 27 23
4,5 21 47 35 24 20
5 17 41 31 21 17
5,5 13 36 27 18 15
6 11 32 24 16 13
6,5 9 28 21 14 12
7 7 25 19 13 11
The cross beams may only be mounted in horizontal and vertical alignment with suitable tools, must be connected
symmetrically with at least 4 bolts M8 of quality 8.8 and tightened with a torque of 3 Nm.
7,5 6 22 17 11 9
8 5 20 15 10 8
The cross beams and connectors must be checked for damages and deformations before each use.
8