TILBURY Bed Frame with Headboard INSTRUCTION GUIDE v 2.
WARNING WARNING! ¡ADVERTENCIA! ATTENTION! • Keep small parts out of reach of children. • Make sure the bed frame’s legs remain in contact with the ground. • Do not use this product if parts are missing, damaged, or worn. • Do not stand on the product. • Clean with a sponge and warm soapy water. • Never use abrasives or chemicals to clean. • Do not use solvent-based cleaners or detergents as they can bleach or damage the product. • For wood beds, vacuum or brush with a soft brush on a regular basis.
PARTS Headboard Legs Front Rail Support Rail Footboard Legs Sideboard Center Leg E-2X A-2X C-2X D-1X F-2X B-3X Slats Center Rail G-1X H-2X Center Screw Allen Wrench Screw I-1X J-22X K-1X 3
ASSEMBLY INSTRUCTIONS STEP 1 B A E A FRONT HEADBOARD ASSEMBLY: A Lay headboard legs (A & A) flat on floor. Screw the front rail (B) and Support rail (E) into the holes in the side of the headboard legs. The rails should cover the flanges on the headboard legs. Use screws (J) to fasten.
ASSEMBLY INSTRUCTIONS STEP 3 x2 C C E C FRONT FOOTBOARD ASSEMBLY: Lay headboard legs (C& C) flat on floor. Screw the support rail (E) into the holes in the side of the footboard. Use screws (J) to fasten.
ASSEMBLY INSTRUCTIONS STEP 4 F E A x4 C A F E C F E C ASSEMBLE THE SIDEBOARD: Attach both sideboards (F) to the assembled headboard and footboard. Flanges on the sideboard should face inward and velcro 6 should face upwards.
ASSEMBLY INSTRUCTIONS STEP 5 G ASSEMBLE THE CENTER RAIL: Attach the center leg (D) to the center rail (G) using the center screw Lift the center rail (G) and push down to lock into place on the support rails. Tighten with center screw (I). G E STEP 6 ATTACH THE SLATS: Attach to the frame by laying slats on the velcro on the side rails.
BED SAFETY GUIDE HEADBOARD WARNING! The Entrapment distance cannot be greater than 3-Inches. Entrapment Distance is the gap between the highest point of the Mattress and the lowest point of the Headboard. Mattress should be sized accordingly. MATTRESS ¡ADVERTENCIA! La distancia de atrapamiento no puede ser superior a 3 pulgadas. La distancia de atrapamiento es la brecha entre el punto más alto del colchón y el punto más bajo de la cabecera. El colchón debe tener el tamaño adecuado.
