Manual












9


o Temporally place Vanity (A) and other desired unit previously attached in place on wall.
o NOTE: Line up Vanity back Support with Wall wood support (B) so that the unit hangs above the floor
and flush against the wall.
o Mark holes at back of Vanity (A) and other desired unit for placement of Anchors (C).
o Pull
Vanity (A) and other desired unit off wall and drill marked holes in wall and insert Anchors (C).
o Place
Vanity (A) and other desired unit back on to wall and line up all holes and attach using Wall
screws (D).
o Use
Hole cover (E) to cover all viewable holes on Vanity (A).
o Refer to
Figure #4.
E
D
C
B
Figure #4
Finished wall
Finished oor
Vanity back support