Specification Sheet

PLEASE CONTACT 1-866-DECOLAV (332-6528) FOR FURTHER ASSISTANCE

DECOLAV.COM

ASSEMBLY INSTRUCTIONS

• Prior to installation, unpack your new DECOLAV

product and inspect it

Keep the product in its original package until you are ready to install it

• Shut the water supply off when replacing an existing xture

• Observe all local plumbing and building codes

• It is recommended that this installation be done with a minimum of two

people. Do not install this xture alone

BEFORE YOU BEGIN

NOTE: Use Decolav decorative bottle trap

item # 9102-CP/SN/PN to complete your new look.

NOTE: Use DECOLAV

drain item # 9295-CP/SN/PN or # 9297-CP/SN/PN.

DECOLAV

cannot guarantee against leakage with other manufacturers drains.

Figure 1

1819W-8B-CWH

Item # 1819W-8B-CWH

• To ensure adequate support, DECOLAV recommends removing

wall board and re-enforcing area with 2” x 4” (5.08 cm x 10.16cm)

wall support crosspiece or 3/4” thick plywood for ease of location

• Measure the desired location of the steel support

and mark mounting hole guidelines on wall

• Check alignment of mounting hole guidelines against steel support

to ensure product is level

• Drill mounting holes in nished wall through wall support crosspiece

• Screw bracket into wall support

• Apply silicone to top edge of steel support

• Apply silicone to back wall of lavatory

• Gently place lavatory in steel support

• Wipe away any excess silicone

• Install faucet, drain, and waste system (not included),

ensuring that supply lines are secured tightly

NOTE: DO NOT OVER TIGHTEN DRAIN. MAY RESULT IN DAMAGE

• Turn on water supply to faucet and check for leaks

• Refer to the below gure for nished product

SECURING THE STEEL SUPPORT TO THE WALL

SECURING THE LAVATORY TO THE STEEL SUPPORT

Figure 2