Use and Care Manual

PLEASE CONTACT 1-866-DECOLAV (332-6528) FOR FURTHER ASSISTANCE

DECOLAV.COM

ASSEMBLY INSTRUCTIONS

NOTE: Use DECOLAV

decorative bottle trap item #

9102-CP/SN/PN to complete your new look.

NOTE: Use DECOLAV

drain item # 9290-CP/SN/PN, #

9296-CP/SN/PN or # 9298-CP/SN/PN. DECOLAV

cannot

guarantee against leakage with other manufacturer drains.

• Prior to installation, unpack your new DECOLAV

product and inspect it

Keep the product in its original package until you are ready to install it

• Shut the water supply off when replacing an existing xture

• Observe all local plumbing and building codes

• It is recommended that this installation be done with a minimum of two

people. Do not install this xture alone

• Afx provided template to countertop at desired location

• Mark guidelines on countertop in several places

• Drill a clearance hole approximately 1/4" to 1/2" inside the

perimeter line of the template

• Cut opening following the perimeter line of template

• Check for cutout alignment by placing lavatory in desired

mounting position

• Apply Plumber’s Putty or Caulking around the underside

of rim near the edge as shown.

• Carefully lower Lavatory in place, align, and press rmly.

• Wipe off excess sealant.

• Allow sealant to set before proceeding to install drain,

waste system, faucet and water supply according

to manufacturer’s installation instructions

NOTE: DO NOT OVER TIGHTEN THE DRAIN.

MAY RESULT IN DAMAGE.

• Check for leakage

BEFORE YOU BEGIN

UTILIZING THE CUTOUT TEMPLATE

INSTALLING LAVATORY

Clearance Hole Cut Opening

1453-CWH

Item # 1453-CWH

BOTTOM VIEW

Apply

Sealant

Here

Lavatory

Countertop