Owner Manual_2

ASSEMBLY INSTRUCTIONS

7. Place back fan grill (G)over corresponding plastic

columns on fan motor assembly (J).Secure back fan

grill (G) to motor assembly(J) with back grill locking

nut (F). Turn clockwise to tighten.

8. Insert and slide fan blade(E) onto fan motor shaft (H)

until the blade rests against the shaft pin. Screw on and

tighten fan blade locking cap (D) by turning counter-

clockwise (to the left).

9. Hook the front grill (C)over the back grill (G) to

make

them temporarily fixed.

10. Remove plastic cap (Y) and aside.

Remove the safety screw and nut (X).

Place the guard ring (A) over the

rims of grills and make them totally fixed. Re-tighten

the safety screw and nut (X) and replace plastic cap(Y).

11. Use the cord clips (Q) to grasp the power cord and keep it in place up against the pole.