6” Outdoor Misting Fan Deco Breeze R is a registered trademark of GPR,Inc. All Rights Reserved.
A B C E D G F H I J K L M N X Y O P Z Q R T U V W PART DESCRIPTION Q’TY PART DESCRIPTION Q’TY A GUARD RING 1 N UPPER POLE 1 B LOGO PLATE / ADJUSTABLE MIST KNOB 1 O POWER CORD 1 C FRONT FAN GRILL 1 P HEIGHT ADJUSTMENT KNOB 1 D FAN BLADE LOCKING CAP 1 Q CORD CLIP 2 E FAN BLADE 1 R LOWER POLE 1 F BACK GRILL LOCKING NUT 1 T FAN BASE 1 G BACK FAN GRILL 1 U WEIGHT 1 H MOTOR SHAFT 1 V WASHER 1 I OSCILLATION KNOB 1 W L-SHAPED LOCKING SCREW
ASSEMBLY INSTRUCTIONS 1 1. Insert lower pole(R) into top of base(T). R T U V W 2. From bottom insert the threaded end of the L-shaped locking screw (W) into the hole of the washer (V) and through the weight (U) and the base(T). 2 R W 3. Turn the L-shaped locking screw (W) clockwise to securely attach the pole (R) to the base(T). V U T 4. Set the base on the floor and extend the upper pole (N) to the desired height. 3 J M 5. Remove locking screw (M) from upper pole (N). 6.
ASSEMBLY INSTRUCTIONS 7. Place back fan grill (G)over corresponding plastic columns on fan motor assembly (J).Secure back fan grill (G) to motor assembly(J) with back grill locking nut (F). Turn clockwise to tighten. 8. Insert and slide fan blade(E) onto fan motor shaft (H) until the blade rests against the shaft pin. Screw on and tighten fan blade locking cap (D) by turning counterclockwise (to the left). 9. Hook the front grill (C)over the back grill (G) to make them temporarily fixed.
OPERATING INSTRUCTIONS 1.The speed adjustment knob (K) is located on the back of fan motor assembly (J). Select Fan Speed = 0 - off 1- Low Speed 2- Medium Speed 3 - High Speed Simply rotate knob to desired position to operate. 2. The fan can operate in stationary or oscillation mode. The oscillation knob (I) is located on the top rear of fan motor assembly (J). To engage the oscillation function, simply depress the button. To stop, pull up. I K J 3. The fan features a telescoping upper pole (N).
5. The adjustable mist knob (B) is located on the front of the fan grill (C). Select mist volume = 2 - 2 nozzles work 3 - 3 nozzles work 1 - 1 nozzle works The misting device is preassembled. For a cleaner appearance, use the enclosed plastic clips to secure the misting hose to the lower pole. Attach the Valve onto a standard outdoor hose. Turn your water on at the spigot and use the lever on the Valve to turn water on and off. Note : The misting nozzles are non-adjustable.
TROUBLESHOOTING Do not attempt to repair or modify and mechanical or electrical pars of this fan. Doing so may void the warranty. PROBLEM The fan will not operate. CORRECTIVE ACTION Confirm that the fan switch is not in the OFF position. Confirm the plug connectors are perfectly joined. The Fan will not oscillate. Push down on knob on top of motor housing to active oscillation. CARE AND MAINTENANCE Always unplug the appliance from the power supply before servicing.
