SDS

6. Accidental release measures
SPILL AND LEAK RESPONSE: Absorb spill with inert material (e.g. vermiculite, sand, or earth), then place in suitable container for disposal. Clean up
spills immediately, observing precautions.
US Regulations (CERCLA) require reporting spills and releases to soil, water and air in excess of reportable quantities. The toll free number for the US
Coast Guard National Response Center is [phone].
DISPOSAL: Dispose of in accordance with applicable Federal, State, and local procedures (see Section 13, Disposal Considerations).
7. Handling and storage
WORK PRACTICES AND HYGIENE PRACTICES: Do not eat, drink, smoke, or apply cosmetics while handling this product.
STORAGE AND HANDLING PRACTICES: Store in a tightly sealed container. Store in a cool, dry, well ventilated area. Protect from physical damage.
8. Exposure controls - personal protection
VENTILATION AND ENGINEERING CONTROLS: Use with adequate ventilation to ensure exposure levels are maintained below the limits provided
below. Use local exhaust ventilation, and process enclosure if necessary, to control airborne dust. Ensure eyewash/safety shower stations are available near
areas where this product is used.
EXPOSURE LIMITS/GUIDELINES
Component Name: CAS # ACGIH TLVs OSHA-PELs NIOSH-TLVs Other
Acrylate Polymer Solution 28205-96-1 Not Listed Not Listed Not Listed Not Listed
Non-Hazardous Colorants Non-Hazardous Mixture Not Listed Not Listed Not Listed Not Listed
Titanium Oxide 13463-67-7 Not Listed Not Listed Not Listed Not Listed
Diethylene Glycol 111-46-6 Not Established Not Established Not Established MAK: 10 ppm; 44 mg/m³
Kaolin 1332-58-7 Not Listed Not Listed Not Listed Not Listed
Glycol Ether 29911-28-2 Not Listed Not Listed Noth Listed Not Listed
Water 7732-18-5 Not Listed Not Listed Not Listed Not Listed
International exposure limits may be established for the components of this product. Please check with competent authority in each country for the most
recent limits in place.
The following information on appropriate Personal Protective Equipment is provided to assist employers in complying with OSHA regulations found in 29
CFR Subpart I (beginning at 1910.132) or equivalent standard of Canada, or standards of EU member states (including EN 149 for respiratory PPE, and EN
166 for face/eye protection), and those of Japan. Please reference applicable regulations and standards for relevant details.
RESPIRATORY PROTECTION: Not required with normal use. If necessary, use only respiratory protection authorized in the U.S. Federal OSHA
Respiratory Protection Standard (29 CFR 1910.134), equivalent U.S. State standards, Canadian CSA standard Z94.4-93, the European Standard EN149, or
EU member states.
EYE PROTECTION: Not normally required however, safety glasses are recommended as appropriate to prevent eye contact. If necessary, refer to U.S.
OSHA 29 CFR 1910.133, Canadian Standards, and the European Standard EN166, Australian Standards, or relevant Japanese Standards.
HAND PROTECTION: Not required under normal use. If desired, wear rubber gloves to prevent skin contact. If necessary, refer to U.S. OSHA 29 CFR
1910.138, the European Standard DIN EN 374, the appropriate Standards of Canada, Australian Standards, or relevant Japanese Standards.
BODY PROTECTION: Not required under normal use. Wear appropriate clothing sufficient to prevent skin contact. If necessary, refer to appropriate
Standards of Canada, or appropriate Standards of the EU, Australian Standards, or relevant Japanese Standards.
9. Physical and chemical properties
VAPOR DENSITY: Not Available
SPECIFIC GRAVITY @ 20°C: Not Available
VAPOR PRESSURE: Not Available
FREEZING POINT: Not Availble
ODOR THRESHOLD: Mild
APPEARANCE, ODOR and COLOR: This product is a liquid with a mild odor.
EVAPORATION RATE (n-BuAc=1): Not Available
SOLUBILITY IN WATER: Not Available
pH: Not Available
BOILING POINT: Not Available
SAFETY DATA SHEET
Page 3 of 5