Safety Data Sheets (SDS)
DECKWISE
®
, THE IPE CLIP
®
 FASTENER COMPANY, LLC 
SAFETY DATA SHEET 
DeckWise® WiseCoat™ 
DeckWise
®
, The Ipe Clip
®
 Fastener Co., LLC Page 6 of 6      
15.3 EUROPEAN ECONOMIC COMMUNITY INFORMATION: 
This product does not meet the definition of a hazardous substance or preparation as defined by the European Union 
Council Directives 67/548/EEC, 1999/45/EC, 1272/2008/EC and subsequent Directives. 
  See Section 2 for Details 
CHEMICAL SAFETY ASSESSMENT : 
  No Chemical Safety Assessment has been carried out for this substance/mixture by the supplier. 
SECTION 16. OTHER INFORMATION 
Caution: HMIS and NFPA ratings are based on a 0-4 rating scale 
0= Minimal Hazard 
1= Slight 
2= Moderate 
3= High 
4= Extreme 
HMIS Rating (Scale 0-4) 
Health hazard: 0 
Flammability: 0 
Physical Hazard: 0 
NFPA Rating (Scale 0-4) 
Health hazard: 0 
Flammability: 0 
Physical Hazard: 0 
Abbreviations and acronyms 
ACGIH 
American Conference of Governmental Industrial Hygienists  
CFR 
Code of Federal Regulations 
DOT 
Federal Department of Transportation 
GHS 
The Globally Harmonized System of Classification and Labelling of Chemicals 
HMIS 
Hazardous Material Identification System 
HCS 
Hazard Communication Standard 
IARC 
International Agency for Research on Cancer 
IATA 
The International Air Transport Association  
ICAO 
The International Civil Aviation Organization 
IMDG 
International Maritime Dangerous Goods 
IMO 
International Maritime Organization 
LD50/LC50 
Lethal Concentration/Dose, 50 percent 
NFPA 
National Fire Protection Association 
NIOSH 
National Institute for Occupational Safety and Health 
NTP 
National Toxicology Program 
OSHA  
Occupational Safety and Health  
PEL 
OSHA Permissible Exposure Limit 
SARA 
Superfund Amendments and Reauthorization Act 
TLV 
ACGIH Threshold Limit Value 
TWA 
Time-Weighted Average 
PREPARED BY:    Chris Eigbrett             MSDS to GHS Compliance 
DATE OF PRINTING:  March 6, 2018                               www.MSDStoGHS.com 
The information contained herein is believed to be accurate but is not warranted to be so. Data and calculations 
are based on information furnished by the manufacturer of the product and manufacturers of the components of 
the product. Users are advised to confirm in advance of the need that information is current, applicable and suited 
to the circumstances of use. U·C Coatings, LLC assumes no responsibility for injury to vendee or third party 
person proximately caused by the material if reasonable safety procedures are no adhered to as stipulated in the 
data sheet. Furthermore, U·C Coatings, LLC assumes no responsibility for injury caused by abnormal use of this 
material even if reasonable safety procedures are followed.  
END OF SDS SHEET 






