TDS

Page 1 of 3

SAFETY DATA SHEET

DATE PREPARED: October 1, 2016

Identity (as used on label and listings): Ipe Seal, Wise Seal, Cedar Seal

Chemical Family/Specific Type: Water-based emulsions / aqueous emulsion of wax

Recommended Use: Sealer coating for the ends of logs and lumber

Manufacturer: DeckWise, The Ipe Clip Fastener Co. Telephone Number: 941-896-9851

2111 58

Ave. East Fax Number:

941-896-9858

Bradenton, FL 34203 U.S.A. Emergency Telephone No.: 941-896-9851

Health Hazards: Ingestion Category 4

Skin irritation Category 3

Eye irritation Category 2B

Hazard Pictogram:

Signal Word: WARNING

Hazard Statements: Physical Hazards: None

Health Hazards: H316 Causes mild skin irritation

H320 Causes eye irritation

Environmental Hazards: This substance is not expected to be toxic to aquatic organisms. However, it is still

advised that this substance does not enter the environment.

Precautionary Statements:

Prevention: P264 Wash affected areas thoroughly after handling

P280 Wear protective gloves and eye protection

Response: P331 IF SWALLOWED: Rinse mouth. Drink large amounts of water. Do not induce vomiting (aspiration

hazard). Seek medical help immediately for ingestion of wax and soap.

P302 IF ON SKIN: Wash with plenty of with soap and water. Remove contaminated clothing. If irritation

persists, seek medical attention.

P305 IF IN EYES: Flush eyes immediately with large amounts of water, using soap if possible. Remove

contact lenses if present and easy to do. If irritation continues, seek medical attention.

Storage: Store above 5ºC / 40ºF. Product can be damaged by freezing.

Disposal: P501 Dispose of contents/container in accordance with local, regional and federal regulations.

NFPA/HMIS Ratings (scale 0-4): HEALTH = 1 FIRE = 1 REACTIVITY = 0 (0 = Minimal Hazard 4 = Severe Hazard)

Protective Equipment: Protective gloves and eye protection

Chemical Characterization: Mixture / water-based emulsion

CAS No.

Main Ingredient: Petroleum Wax 64742-61-6 25-30%

Classified Ingredients: None

No other classified ingredients are present which contribute to this product’s GHS Hazard Categorization

as prescribed by OSHA’s Hazard Communication 29 CFR 1910.1200

1. IDENTIFICATION

2. HAZARD(S) IDENTIFICATION

3. COMPOSITION / INFORMATION ON INGREDIENTS

PRODUCT NAME: IPE SEAL; WISE SEAL; CEDAR SEAL

PAGE 1
Page 1 of 3 SAFETY DATA SHEET PRODUCT NAME: IPE SEAL; WISE SEAL; CEDAR SEAL DATE PREPARED: October 1, 2016 1. IDENTIFICATION Identity (as used on label and listings): Ipe Seal, Wise Seal, Cedar Seal Chemical Family/Specific Type: Water-based emulsions / aqueous emulsion of wax Recommended Use: Sealer coating for the ends of logs and lumber Manufacturer: DeckWise, The Ipe Clip Fastener Co. Telephone Number: 941-896-9851 2111 58th Ave. East Fax Number: 941-896-9858 Bradenton, FL 34203 U.S.A.
PAGE 2
Page 2 of 3 PRODUCT NAME: IPE SEAL 4. FIRST AID MEASURES After Eye Contact: Flush eyes immediately with large amounts of water, using soap if possible. Remove contact lenses if present and easy to do. If irritation continues, seek medical attention. After Skin Contact: Wash with plenty of soap and water. Remove contaminated clothing. If irritation persists, seek medical attention. After Swallowing: Rinse mouth. Drink large amounts of water. Do not induce vomiting (aspiration hazard).
PAGE 3
Page 3 of 3 PRODUCT NAME: IPE SEAL 9. PHYSICAL & CHEMICAL CHARACTERISTICS (continued) Vapor Pressure: same as water Specific Gravity: 0.97 - 0.99 typical Vapor Density (air = 1): same as water Evaporation Rate (butyl acetate = 1): <1 Solubility In Water: infinitely diluteable Volatile Organic Compounds: None Volatile Hazardous Air Pollutants: None Organic Hazardous Air Pollutant Solvents: None. 10. STABILITY AND REACTIVITY Reactivity: Non-reactive under normal temperatures and conditions.