Installation Guide

Step 9 Determine the length of the balusters. Figure 3 illustrates how a 36"
high railing might be sized. Use figure 3 as a planning tool to determine the
height to cut the post sleeves and the balusters. Note: Use a fixture to ensure
a consistent length (+/- 1/16"). Install balusters on each connector. Gently tap the
balusters with a rubber mallet to eliminate any gaps. Check for level end to end.
Tip: Wrap painters tape around the back side of both posts and place balusters
against the tape. The tape will balance the balusters in place until the upper rails
are installed. Remove tape when upper rail is in place.
Step 10 Important: When using Deckorators Designer Baluster Connectors
(both Estate and Classic) in conjunction with the stair adaptors, the upper inner
rail must be inverted (figure 5). Use an exterior adhesive on the underside of
the Designer Baluster Connectors to prevent the balusters from spinning. Install
the remaining baluster connectors and stair adaptors (if applicable) on the
underside of the upper inner rail. Set the rail onto the balusters, gently tapping
the rail to remove any gaps. Attach the upper inner rail to the brackets by pre-
drilling 1/8" holes at each bracket hole and into the inner rail. Fasten the rail to
the bracket using 1" countersunk screws.
Step 11 Measure the distance between the posts and, trim the upper outer rail
to length, and set on the assembly. Important: Taking care not to drill all the way
through the upper rail, use a 1/8" drill bit to pre-drill four 1/2" deep holes, equally
spaced, through the underside of the inner rail and into the underside of the
upper rail. Tip: Place a piece of tape 1-1/2" from the end of the drill bit. Do not
drill past the tape. Fasten cap rail in place using four 1-1/2" pan head screws.
Step 12 Apply construction adhesive to the inside edges of the post caps and
place over each post sleeve.
Note: Touch-up paint is available to repair any chips or blemishes that occur
during assembly and installation. Contact a Deckorators customer service
agent at 800-332-5724 for availability.
THE DIAGRAMS AND INSTRUCTIONS IN THIS BROCHURE ARE FOR ILLUSTRATION PURPOSES ONLY AND ARE NOT MEANT TO REPLACE A LICENSED PROFESSIONAL. ANY CONSTRUCTION OR USE
OF THE PRODUCT MUST BE IN ACCORDANCE WITH ALL LOCAL ZONING AND/OR BUILDING CODES. THE CONSUMER ASSUMES ALL RISKS AND LIABILITY ASSOCIATED WITH THE CONSTRUCTION
OR USE OF THIS PRODUCT. THE CONSUMER OR CONTRACTOR SHOULD TAKE ALL NECESSARY STEPS TO ENSURE THE SAFETY OF EVERYONE INVOLVED IN THE PROJECT, INCLUDING, BUT NOT
LIMITED TO, WEARING THE APPROPRIATE SAFETY EQUIPMENT. EXCEPT AS CONTAINED IN THE WRITTEN LIMITED WARRANTY, THE WARRANTOR DOES NOT PROVIDE ANY OTHER WARRANTY,
EITHER EXPRESS OR IMPLIED, AND SHALL NOT BE LIABLE FOR ANY DAMAGES, INCLUDING CONSEQUENTIAL DAMAGES.
©2012, 2014 Universal Forest Products. Deckorators is a registered trademark of Universal Consumer Products, Inc. in the U.S. All rights reserved.
933 US Route 202 Greene, ME 04236-3466
8104 PROAlumGlass 11/15
www.deckorators.com