Installation Guide
Installation Tips
Dimensions plastic lattice can be cut and drilled using standard 
tools. Use rustproof or rust-resistant fasteners to maintain the  
beauty of your project over time. For a distinguished look, 
frame panels with plastic caps and connect panels with plastic 
dividers. Always allow a 1/4" gap between the lattice edge and 
moulding for the panel to expand and contract with tempera-
ture changes. Lattice must be attached to a self-supporting 
structure or frame. Suspend lattice from top row of fasteners.
•
 Along the top, use a 1/4" drill bit to predrill oversized holes 
every two feet through both the moulding and lattice. 
Fasten with screws, taking care not to over-tighten. Along  
the sides and bottom, predrill oversized holes every two 
feet through the moulding only and fasten with screws. 
Again, be careful not to over-tighten the screws.
•
  Do not install lattice in a horizontal application.  
Without proper support, lattice will be prone to  
sagging, rippling and heat retention.
•
  Standard Dimensions lattice is a nonporous  
material. Coatings such as paint and stain do not  
adhere well to the surface.
Paintable Lattice Painting Tips
•
 Clean the surface of the paintable plastic lattice 
sheet with a solution of warm water and dish soap. 
Rinse and allow to dry.
•
  Apply two thick coats of an aerosol primer for plastic
*
over the entire surface, as instructed on the can. 
Allow to dry between coats. 
•
 Once dry, apply a thin coat of any aerosol paint over 
the entire surface, per product directions. Allow to 
dry as directed. Apply a second coat of aerosol paint 
over entire lattice sheet. Allow to dry as directed.
* 
Paint for Plastic can be used without primer per product instructions.
Lifetime Limited Warranty
•
 Universal Consumer Products, Inc. offers an express 
limited warranty for Dimensions plastic lattice at 
DimensionsDIY.com.
1/4" GAP 
Add dimension to your space.
Check out our Dimensions Pinterest page for inspiration 
and creative ideas on how to use lattice for an endless 
number of indoor and outdoor projects.
White Privacy Diamond
White Privacy SquareClay Classic Diamond
Driftwood Gray Privacy Diamond
Paintable Classic Diamond
Black Classic Diamond
2801 East Beltline NE 
•
 Grand Rapids, MI 49525 
•
 800.556.8449 
•
 DimensionsDIY.com  
Dimensions is a trademark of Universal Consumer Products Inc, in the U.S.
©2016 Universal Forest Products, Inc. All rights reserved. 8841_6/16




