Instructions / Assembly

THE DIAGRAMS AND INSTRUCTIONS IN THIS BROCHURE ARE FOR ILLUSTRATION PURPOSES ONLY AND ARE NOT MEANT TO REPLACE A LICENSED PROFESSIONAL. ANY CONSTRUCTION OR
USE OF THE PRODUCT MUST BE IN ACCORDANCE WITH ALL LOCAL ZONING AND/OR BUILDING CODES. THE CONSUMER ASSUMES ALL RISKS AND LIABILITY ASSOCIATED WITH THE
CONSTRUCTION OR USE OF THIS PRODUCT. UNIVERSAL CONSUMER PRODUCTS, INC. DOES NOT PROVIDE ANY WARRANTY, EITHER EXPRESS OR IMPLIED, AND SHALL NOT BE LIABLE FOR ANY
DAMAGES, INCLUDING CONSEQUENTIAL DAMAGES.
Deckorail.com
©2017 Universal Forest Products, Inc. All rights reserved. DeckoRail is a registered trademark of Universal Forest Products, Inc., in the U.S.
9218_2/17
Step 4
Lift the table into position, and then slide it into the slots on the elbows.
Tighten the thumb screw on the bottom of each elbow to secure frames
in place.
Note: The offset crosspieces on the frame allow the table to
be installed so it extends more towards the center of the deck for more
of a ledge, or further away from the deck, depending on your use.
WARNING!
• Maximum weight capacity is 50 lbs uniformly distributed. Do not exceed.
• Table is designed to attach to a guardrail that meets the structural
requirements of the International Residential Code. Do not use if the
guardrail does not meet the International Residential Code or if the
guardrail is otherwise unsafe or dilapidated.
• While it is designed to work with many common railing styles, do not
use or force to fit a non-compatible railing.
• Never allow any person to sit on, stand on, lean on, or pull themselves
up by the table.
• Check with your homeowner’s or condo association for rules regarding
installation and use.
• It is a best practice to remove the table and hardware when not in use.
Always remove prior to storms or high winds.
• Check your local zoning ordinance for rules on installation and use.
• Maximum weight is inclusive of the weight of whatever material is used
as a table top.
• Prior to installing or removing, ensure nothing (including any people,
animals, furniture, etc.) is below the railing.
• The bracket clamps and thumbscrew should be checked and
re-tightened (if necessary) before every use, especially if the table
has remained attached to a railing for a long period of time.
• If the table top becomes loose from the “H” frames, re-tighten screws
attaching the table top or install a new table top before use.
Step4.ai
Step4.ai
Step5Note.ai
Center Mount Table or Bar Mount
Step5Note.ai
Center Mount Table or Bar Mount
Step 4
Center Mount
Table or Bar Mount