Product Manual B

PREPARE VAN: INSTALL SHIMS

There are 10 shims provided:

1) If your vehicle is equipped with a rubber floor mat in the cargo area, you will need to remove the

screws securing the plastic trim pieces at the base of the rear door and side door openings, and

remove and set aside the plastic trim pieces. If no mat is installed, follow step 3 on this page.

2) At the rear door opening, lift the floor mat and fold it forward so it is clear of the floor area where

the shims will be placed.

3) Using the information in the respective circular detail views on the next page:

a) Clean the surfaces where the shims will be located.

b) Remove the layer of tape on the bottom of the shim to expose the adhesive surface.

c) Place the shim and apply with pressure.

NOTE: Repeat steps A and C on passenger side.

4) When all shims are placed, roll the rubber mat back to cover the floor.

5) Reinstall the plastic side and rear door trim pieces and secure with screws.

FRONT

REAR