Assembly Instructions

PREPARE VAN: INSTALL SHIMS
There are 2 shims provided:
1) If your vehicle is equipped with a rubber floor mat in the cargo area, you will need to remove the
screws securing the plastic trim pieces at the base of the rear door and side door openings, and
remove and set aside the plastic trim pieces. If no mat is installed, follow step 3 on this page.
2) At the rear door opening, lift the floor mat and fold it forward so it is clear of the floor area where
the shims will be placed.
3) Using the information in the respective circular detail views on the next page:
a) Clean the surfaces where the shims will be located.
b) Remove the layer of tape on the bottom of the shim to expose the adhesive surface.
c) Place the shim and apply with pressure.
NOTE: Step A is to be repeated on passenger side.
4) When all shims are placed, roll the rubber mat back to cover the floor.
A
DETAIL A
Place shim 5 3/4” from body bolt in floor
(blue dot). Place shim 1/2” inboard from
floor bead (red). Repeat Passenger side.
5 3/4” GAP
1/2” GAP
FRONT
REAR