Installation Guide

MN3 | V1 | Page 3

HELPFUL TIP: This step seems like a waste of time,

but Dr. DECKED says it's important...don't skip out.

ASSEMBLY: ALIGN & TIGHTEN STUDS (YUP)

NOTE: This step ensures the studs are properly located before tightening bolts. It's important.

• Place ammo cans to support tailgate end of deck panels.

• Lift deck panels on center vert + stud + cabside vert assembly.

• Slide studs around L-R until deck panels are seated.

• DETAIL A: Loosely secure four bolts to hold decks onto studs; BAG S1.

• Now you can securely tighten the bolts that hold the studs to the cabside vert.

• Unbolt deck from studs, remove deck panels, save bolts, remove ammo cans and set aside for later assembly.

DETAIL A

YOU WILL REMOVE AND SAVE THESE BOLTS

AFTER TIGHTENING CABSIDE VERT + SHIM

BOLTS

TIGHTEN AND SECURE