Product Manual B

MF3 & MF4 | v.1 | Page 4
DECKED.COM | #DECKEDUSA | @DECKEDUSA
DETAIL A
Align narrow shim to channel in floor as
shown 5.5" from rear of bed (red).
PREP BED: SHIMS
• 2 WIDE SHIMS and 1 NARROW SHIM loose in your hardware kit.
• Using the information below:
1) Clean the bed surface where the shims will be located. Isopropyl alcohol is recommended.
2) Remove tape film and apply shim with pressure.
A
B
DETAIL B
Align shim 2.5" from cabside panel (red) as shown.
Repeat on right side of bed.
5.5"
2.5"