Product Manual B
Page 6 | v.4 | DR6 / DR7 DECKED. COM | #DECKEDUSA | @DECKEDUSA
TAILGATE AMMO CAN AXLE CABSIDE AMMO CAN VERT AXLE CCHANNEL ENDPLATE
CS AMMO CANS
B1
B1
CCHANNELS C
ASSEMBLY: DRIVER’S SIDE DECK
(LET’S DO THIS!)
• There are three pre-installed gaskets – one on the center vert, one on each underside of the decks where they rest
on the center vert. Do yours look weird? See them here: DECKED.COM/GASKETS
• Place C-channel on the inside ledges of a cabside ammo can and a tailgate ammo can.
• The end of the C-channel with the endplate must rest on the cabside ammo can.
• Verify that the tailgate ammo can’s axle is closest to the tailgate; if not, grab the other tailgate ammo can.
• Loosely bolt C-channel to the two ammo cans with (4) nylon washers on
the (4) bolts. Make sure the bolt head is on the C-channel side, not inside
the ammo can; BAG CCHANNELS C. Don’t tighten yet.
• Line up the driver’s side deck (sticker on end of deck panel indicates LEFT/DRIVER) on top of the
C-channel/ammo can assembly and the center vert bosses. NOTE: Tailgate side of the center vert has an axle
installed; the center vert and ammo can axles must be on the tailgate end (not cabside end) of the assembly.
• Bolt the deck to the ammo cans; BAG B1 for the tailgate ammo can, BAG CS AMMO CAN for the cabside ammo can.
• Now go back and tighten the loose bolts connecting the ammo cans to the C-channel.
• Bolt the deck to the center vert; BAG B1: Do not use power tools!
• Grab your buddy to help you lift the assembly into the driver side of the truck bed.
DRIVER SIDE DECK HALF
➡
CAB
RECOMMENDED TORQUE: Bolts in labeled bags C-CHANNELS C,
CS AMMO CAN and B1 - 27 in-lb.
NYLON WASHER