Product Manual B

DG6/DG7/DG8 | v.6 | Page 8DECKED.COM | #DECKEDUSA | @DECKEDUSA
➡
CAB
B1
NO WASHERS
B1
NYLON + RUBBER WASHERS
CS AMMO CAN
NYLON + RUBBER WASHERS
ASSEMBLY: DRIVER’S SIDE DECK
• There are three pre-installed gaskets – one on the center vert, one on each underside of the decks where they rest on the center vert. Do yours look
weird? (They should be flat.) See them here: DECKED.COM/GASKETS
• Place C-channel on the inside ledges of a cabside ammo can and a tailgate ammo can.
• The end of the C-channel with the endplate must rest on the cabside ammo can.
• Verify that the tailgate ammo can’s axle is closest to the tailgate; if not, grab the other tailgate ammo can.
• Install nylon washers onto all bolts in BAG C-CHANNEL, WASHERS .
• Loosely bolt C-channel to the two ammo cans. Make sure the bolt
head is in the C-channel, not inside the ammo can; BAG CCHANNEL.
Don’t tighten yet.
• Line up the driver’s side deck (sticker or mark on end of deck panel
indicates LEFT/DRIVER) on top of the C-channel/ammo can assembly and the center vert bosses.
Hey Sparky: Tailgate end of the center vert has an axle installed; the center vert axle and ammo can axles must be
on the tailgate end (not cabside end) of the assembly.
• Use WASHERS bag to install nylon & rubber washers on all CS AMMO CAN bolts. Install the same washers on 12 B1 bolts...
• Use the above bolts to bolt the deck to the ammo cans; BAG B1 for the tailgate ammo can, BAG CS AMMO CAN
for the cabside ammo can.
• Now tighten the loose bolts connecting the ammo cans to the C-channel.
• Bolt the deck to the center vert; BAG B1 (no washers). If you must use power tools, use with caution! Set drill clutch to LIGHT.
NYLON
WASHER
RUBBER
WASHER
NYLON
WASHER
RECOMMENDED TORQUE: Bolts
in labeled bags C-CHANNEL,
CS AMMO CAN and B1 - 27 in-lb.
TAILGATE AMMO CAN AXLE
CCHANNEL ENDPLATE
CENTER VERT AXLE
CABSIDE AMMO CAN