Product Manual B

DG6/DG7/DG8 | v.6 | Page 4DECKED.COM | #DECKEDUSA | @DECKEDUSA

PREP BED: SHIMS

• There are 4 SHIMS provided; 2 narrow (DETAIL A) and 2 wide (DETAIL B).

• Using the information in the respective circular detail views:

a) Clean the surfaces thoroughly where the shims will be located (isopropyl alcohol is recommended).

b) Remove the layer of tape on the bottom of the shim to expose the adhesive surface.

c) Place the shim and apply with pressure.

• Repeat DETAIL B on passenger side.

• DETAIL A will depend on your truck bed length (DG6, DG7 or DG8).

DETAIL B

Align wide shim with cabside panel of bed. Center

shim between longitudinal floor beads .

Repeat on passenger side.

➡

CAB

DETAIL A

Depending on your truck, place narrow shims

according to the following bed lengths:

DG6 - 5’9” BED:

Align narrow shims on each side of center floor bead

as shown. Place shims 8” from rear of bed.

DG7 - 6’6” BED:

Align narrow shims on each side of center floor bead

as shown. Place shims 7” from rear of bed.

DG8 - 6’9” BED:

Align narrow shims on each side of center floor bead

as shown. Place shims 9 1/2” from rear of bed.

SEE NOTE BELOW