Installation Guide

877.492.4334 || Deck-Top.com || [e-mail] || 13575 58th Street North, Suite
323 Clearwater, FL 33760
2
DECK-TOP ADHESIVE INSTALLATION:
1. Select a Deck-Top approved adhesive. You must use a Polyurethane PVC to Wood All-Weather based adhesive with
Deck-Top. These types of adhesives have been vigorously tested and tried over time against the elements. Please
see page 1 for a complete list of recommended adhesives.
Note: Regular non-polyurethane adhesives are not a recommended adhesive as they did not perform to our
satisfaction during testing.
2. Apply a bead of adhesive on each inside vertical lip on the right and left sides of Deck-Top.
3. On the underside of the Deck-Top plank, run a back-and-forth bead of adhesive (in a z-like motion) from end-to-
end over the full length of the plank. This will ensure proper coverage when Deck-Top is placed on top of your
decking. One 9 oz. tube of approved adhesive should be used for every 15 linear feet of Deck-Top.
• If any excess glue is applied to any other surface, clean the area immediately. Any uncured sealant needs to
be removed by using the manufacturers’ recommended cleaners. Bostik Specialty Sealant Remover™ or
Mineral Spirits are the recommended cleaning agents. Cured sealant is usually very difficult to remove
without altering or damaging the surface to which the sealant has been misapplied.
4. Place the adhesive-covered Deck-Top plank on top of a decking board with the adhesive-covered side
touching the decking board.
5. Once Deck-Top is placed on top of the decking board, immediately apply pressure to the top surface from end to
end.
6. Follow the adhesive manufacturer’s instructions and recommendation on drying time before walking on your
new deck surface.
YouTube installation videos found on our Deck-Top page. https://www.youtube.com/@deck-top1100/about
CLEANING
Deck-Top is stain-resistant. Common dirt, scuffs, or stains on the flooring can appear over a period of time, but
they can be easily cleaned away with soap and water.
• For stains such as rust or other similar marks on the Deck-Top surface, acetone can be used to clean the
area. Be sure to clean the area with soap and water immediately after using acetone.
QUESTIONS? CONCERNS? JUST NEED SOME HELP?
CONTACT CUSTOMER SUPPORT:
1.877.492.4334 (M–F: 8am to 5pm EST) || [e-mail]