Programming instructions

DECATHLON SERIES GAS FRYERS
CHAPTER 1: SERVICE PROCEDURES
1-22
1.7.8 Replacing the Frypot (cont.)
10. Remove screws securing flue-cap
braces to frypot (a nut-driver with
an extension or long screwdriver
is required). Use care not to drop
the screws into the flues. If this
happens, the screws can be
retrieved when the flue is
removed (Step 16). Use a
screwdriver or similar tool to free
flue cap from frypots. Remove
flue cap by lifting up and off of
fryer.
11. Remove gas manifold pipe for
access to gas manifold shield by
disconnecting at the unions.
Ensure gas supply is shut off and
supply line is disconnected prior
to removing. Set gas manifold
aside. Remove screws securing
gas manifold shield. Remove
shield to access oil-return
plumbing components connected
to the frypots.
NOTE: For units without built-in
filtration skip the steps pertaining
to removal/replacement of oil-
return plumbing.
12. Remove cotter-pin from oil-return
actuator rod. Observe washer
placement prior to removing rod
from the valve actuator (arrows).
Disconnect actuator rod and
remove washers. Set washers
aside for later re-assembly.
Removing flue cap.
Removing gas manifold shield.
Disconnecting oil-return linkage from valve.