Programming instructions

DECATHLON SERIES GAS FRYERS
CHAPTER 1: SERVICE PROCEDURES
1-18
1.7.5 Replacing Rocker Switches
1. Disconnect the fryer from the electrical supply.
2. If switches are located on front panel, remove the screws securing panel to fryer. Do not allow
the panel to hang on the switch wiring harness; use some type of support. If the switches are
located in a control box within the fryer, remove the screws securing the switch panel to the
control box. Do not allow the switch panel to hang from the switch wiring harness.
3. Depress the retaining clips (see illustration below) and push the switch out of the slot. If there is
a switch-guard present, retain it for installation of the replacement switch.
Depress clips on each end to
remove switch from control
panel.
When connecting
wires to replacement
switch, pass the
wires through the
switch guard (if
applicable) before
connecting to switch.
4. Remove wires one at a time from the switch being removed and connect to the replacement
switch until all wires are transferred.
5. Reverse the above steps for reassembly.