Programming instructions

HIGH EFFICIENCY DECATHLON SERIES GAS FRYERS
CHAPTER 1: SERVICE PROCEDURES
1-22
NOTE: If restraints are installed on the fryer, disconnect restraints prior to disconnecting
the gas supply line.
3. Unplug fryer from electrical supply source.
4. Remove fryer door for easier access to the temperature probe. First, remove top hinge from
bracket. Then, lift door off bottom hinge pin.
5. Remove the basket hanger from the flue cap by lifting
up and off of fryer. Some units may have a built-in
flue deflector on the basket hanger. Units with basket
lifts will require the removal of the lift arms prior to
removing the basket hanger.
6. Remove the top cap. It is held in place by one screw
on each side of the fryer. If the fryer has a controller
on the front, the top cap may also be held in place
by two screws on the front of each pot. FPHD65
units may have two screws on each end of the top cap.
7. Remove the joiner strips on either side of the frypot. Be
careful not to bend the joiner strip during removal.
8. Remove back panels of the fryer. There
may be both upper and lower panels and
several screws secure them. Screw
location and orientation will vary
according to fryer model.
Typical screw locations on the back panel (may vary by
model
)
.
Removing the basket hanger from the flue cap.
Removin
g
the
j
oiner stri
p
.