Programming instructions

HIGH EFFICIENCY DECATHLON SERIES GAS FRYERS
CHAPTER 1: SERVICE PROCEDURES
1-12
1.7.2 Replacing Control Box Components including Ignition Module, Interface
Board, Transformers, etc.
1. Disconnect the fryer from the electrical
supply.
2. Unscrew the two controller panel screws.
The controller panel is hinged at the bottom
and will swing open from the top.
3. Locate the component to replace.
4. Mark the location of the wires to facilitate
easy reassembly.
5. Disconnect the wires.
6. Remove the screws attaching the component
to the control box.
7. Reverse steps to complete the replacement
and return the fryer to service.